D16Y8 with Demon V2 P28 ECU Package Engine wont idle

Reply to topic
    Reply with quote

D16Y8 with Demon V2 P28 ECU Package Engine wont idle

mrhimmel Sun Jun 28, 2015 5:59 am

I finished rebuilding my D16Y8 and I wanted to test the Demon V2 P28 ECU. The engine is naturally aspirated for now but I want to have the turbo tuned. The stock P2P ecu will run the engine well. However, I want the P28 demon2 i bought to at least idle the car when I pass it off to the tuners.

I have the OBD1 to OBD2 conversion harness installed. I am trying to use the pre-configured Neptune setup map for the D16Y8 NA (comes with the Neptune RTP software). This is supposedly very good starting points.

However, the engine just turns over and dies, and I can't find any similar problems.



[/img]

_________________
Mike

mrhimmel

 
Posts: 1
Joined: 28 Jun 2015
    Send private message View user's profile

    Reply with quote

HRTuning Sun Jun 28, 2015 12:31 pm

You have full capacity to change the fueling if it's necessary and also to alter the iacv duty. I'd start there.

_________________
Like us on Facebook.
http://www.facebook.com/NepTuneEngineManagement

HRTuning

 
Posts: 10196
Joined: 05 Sep 2004
Location: Phoenix, AZ
    Send private message View user's profile Visit poster's website AIM Address


Reply to topic

General Questions

 

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum