Hey guys,
First, a little about my setup.
Tunerview RD1
Hondata s300 w/ cable
Innovate LC-1 wideband hooked to ECU D10
Wideband analog output to ECU is as follows
0 V 7.35
5.0V 22.39
Settings are identical in both Smanager and Tunerview software
I also have an innovate turbo timer w/ digital AFR gauge hooked to the other analog output of the wideband.
No matter what I seem to do, the digital gauge reads 14.7 AFR, while the tunerview reads 16 AFR. Hooking the Innovate logworks software to my wideband verifies that the reading of analog2 is correct, however, the tunerview doesn't seem to cooperate.
Any suggestions here guys?