Map sensor is reading max psi when trying to start the car

Reply to topic
    Reply with quote

Map sensor is reading max psi when trying to start the car

krazy4 Fri Nov 16, 2018 8:16 pm

Hi guys just started having an issue with the car.

I've replicated this with the omni power 4 bar map and the stock honda 1.75 bar map.

When going to start the car, the datalogger shows 46.3psi with the 4 bar map.
It should show negative when starting the car.

Swapped out to the stock honda map and it reads 11.2psi when starting the car.

As you can guess the car doesnt start or if it does it runs really bad.

Any ideas?
Thanks!

_________________
EG sedan - S366 turbo H23a w/ GSR trans
367whp on 9.5LBS - higher boost coming soon

krazy4

 
Posts: 14
Joined: 12 May 2017
Location: Socal
    Send private message View user's profile

    Reply with quote

HRTuning Fri Nov 16, 2018 9:15 pm

Check the input voltage both in the software and actual, this is hardware issue.

_________________
Like us on Facebook.
http://www.facebook.com/NepTuneEngineManagement

HRTuning

 
Posts: 10379
Joined: 05 Sep 2004
Location: Phoenix, AZ
    Send private message View user's profile Visit poster's website AIM Address


Reply to topic

NepTune RTP Software

 

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum