AFR not reading correctly

Reply to topic
    Reply with quote

AFR not reading correctly

psud3ity Sun Jul 07, 2013 9:17 pm

Hey guys,

First, a little about my setup.

Tunerview RD1
Hondata s300 w/ cable
Innovate LC-1 wideband hooked to ECU D10

Wideband analog output to ECU is as follows
0 V 7.35
5.0V 22.39

Settings are identical in both Smanager and Tunerview software

I also have an innovate turbo timer w/ digital AFR gauge hooked to the other analog output of the wideband.

No matter what I seem to do, the digital gauge reads 14.7 AFR, while the tunerview reads 16 AFR. Hooking the Innovate logworks software to my wideband verifies that the reading of analog2 is correct, however, the tunerview doesn't seem to cooperate.

Any suggestions here guys?

psud3ity

 
Posts: 2
Joined: 17 May 2011
    Send private message View user's profile

    Reply with quote

HRTuning Mon Jul 08, 2013 12:16 am

Try changing the wideband output to acceptable numbers like 0 10 5 20

_________________
Like us on Facebook.
http://www.facebook.com/NepTuneEngineManagement

HRTuning

 
Posts: 10385
Joined: 05 Sep 2004
Location: Phoenix, AZ
    Send private message View user's profile Visit poster's website AIM Address


Reply to topic

TunerView RD 1

 

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum